829 Sheridan Drive :: Tonawanda, NY 14150
(716) 874-6900 Phone :: (716) 874-6966 Fax
I would never write a testimonial if the product didnt work and my experience with the company wasnt this great. So here goes, when i got the product and had it on in a matter of minutes (just like the directions say) and hit the key the thing fired rite...
...read more
From: chris e.
Walt, got my new glow plugs and controller and installed them with new wire connectors and the truck does not smoke anymore on cold start ups. Service is excellent as is the suggestion to replace the wire connectors at time of glow plug replacement. More...
...read more
From: Keith E.
Follow Us on Facebook

H1 Hummer  >  FSD Heat Syncs, PMD's & Resistors  >  #9 Calibration Resistor H1 HUMMER 96+

Brand New #9 Calibration Resistor for all 96+ H1 HUMMERs

#9 Calibration Resistor H1 HUMMER 96+

#9 Calibration Resistor H1 HUMMER 96+

Model: ssd-003 $19.99
United States and Canada - All Deliveries to the United States and Canada will be made by UPS. You will be quoted the shipping cost and presented with delivery options at the time of checkout. See our shipping calculator for more information.
International Customers - Review Shipping Policies
Check Out
 

Brand new  #9 Calibration resistor for all H1 6.5TD H1 HUMMERS 96+.

#1 thru #9 resistors adjust the fuel rate output your injection pump. The #9 is the largest value available. The OEM states a 6% increase in fuel delivery over a stock #5 at full throttle. (aftermarket scam #13 will trip an SES code) Unlike a gas engine, with diesel engines, the more fuel injected, the more hp produced. PROVEN effective by diesel enthusiasts everywhere. Changing the resistor is just like turning up the fuel on the older manual injection pump. You can actually retain your great mileage using this resistor if you drive normally. But, if you put your foot into it, you will see more power and reduced mileage. I personally run a #9 and average around 20 MPG with a K1500 p/u.

The calibration resistor location by design, stradles the PMD connector pins and is sandwiched in place between the harness and the PMD/FSD connector. Average value used stock is a #5, but diesel enthusiasts know that increasing to a #9 is a definate performance boost. Installation instructions included. PMD/FSD's and FSD Heat Syncs are also available.

Notes:

a) Resistor color may vary.

b) Available for all PMDs Black or Gray. If you have a gray PMD, please specify or one for a black PMD will be supplied

c) If you also order a PMD, we will pre-install it inside thePMD's connector cavity for you as a courtesy. Before you contact us saying "it wasn't in the box", please check the PMD's connector cavity for it as shown in the photo below.

#9 Calibration Resistor H1 HUMMER 96+

 

Click to Load this Photo Click to Load this Photo
Visa, MasterCard, Discover, American Express and e-Check, processed by PayPalVerified by PayPal
SSDieselSupply.com - © Copyright 2004-Present
37,170,648 visits since 7/17/2004

Website Development and Web Hosting by Online Media
Online Media - Buffalo's Web Hosting Company