829 Sheridan Drive :: Tonawanda, NY 14150
(716) 874-6900 Phone :: (716) 874-6966 Fax
Thank You for the excellent service and expert knowlege you provide. This was the second time I ordered and once again you guys went above and beyond to help me. All your parts are top quality, well above OEM standards. My truck runs as if I just drove it...
...read more
From: Louie P.
I had the classic performance loss and decreased mpg..with occasional high speed surging, followed by intermittent stalling...and finally complete stall with no start..Researched the problem on the net..Decided the SS Diesel Supply product was both the...
...read more
From: Don C.
Follow Us on Facebook

6.5TD C/K Trucks  >  SSD Heat-Syncs, PMD's and Resistors  >  6.5 Diesel #9 Calibration Resistor

Brand new #9 Calibration resistor. Available for all PMDs Black or Gray

6.5 Diesel #9 Calibration Resistor

6.5 Diesel #9 Calibration Resistor

Model: ssd-003 $19.99
United States and Canada - All Deliveries to the United States and Canada will be made by UPS. You will be quoted the shipping cost and presented with delivery options at the time of checkout. See our shipping calculator for more information.
International Customers - Review Shipping Policies
Check Out

Brand new  #9 Calibration resistor. Fits all GM 6.5 turbo diesels 1994-2004 with electronic fuel injection. Used in Chevy and GMC C/K pick-ups, G/P vans and cab/chassis (buses, etc) and H1 Hummers with electronic fuel injection.

#1 thru #9 resistors adjust the fuel rate output your injection pump. The #9 is the largest value available. The OEM states a 6% increase in fuel delivery over a stock #5 at full throttle. (aftermarket scam #13 will trip an SES code) Unlike a gas engine, with diesel engines, the more fuel injected, the more hp produced. PROVEN effective by diesel enthusiasts everywhere. Changing the resistor is just like turning up the fuel on the older manual injection pump. You can actually retain your great mileage using this resistor if you drive normally. But, if you put your foot into it, you will see more power and reduced mileage. I personally run a #9 and average around 20 MPG with a K1500 p/u.

The calibration resistor location by design, straddles the PMD connector pins and is sandwiched in place between the harness and the PMD/FSD connector. Average value used stock is a #5, but diesel enthusiasts know that increasing to a #9 is a definate performance boost. Installation instructions included. PMD/FSD's and coolers are also available. Please see our other products.

Notes:

a) Resistor color may vary.

b) Available for all PMDs Black or Gray. If you have a gray PMD please specify, or a resistor for a black PMD will be provided

c) If you also order a PMD, we will pre-install this resistor inside the PMD's connector cavity for you as a courtesy. Before you contact us to say "it wasn't in the box", please check the PMD's connector cavity as shown in the photo below.

6.5 Diesel #9 Calibration Resistor

 

Click to Load this Photo Click to Load this Photo
Visa, MasterCard, Discover, American Express and e-Check, processed by PayPalVerified by PayPal
SSDieselSupply.com - © Copyright 2004-Present
34,077,425 visits since 7/17/2004

Website Development and Web Hosting by Online Media
Online Media - Buffalo's Web Hosting Company